What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 23:57
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The other is “what does a “fuse” do?”
eight
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
A circuit breaker is similar, but is resettable.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
what exactly is a ‘surge’ protector?
This device then solves the entire problem.
Edit 2024–10.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
[old diagram got deleted by accident]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
but this device (an Inductor) … impedes the rapid changes in the current.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Commanders CB Lattimore feeling 'way better' - ESPN
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
Fallout 76: Gone Fission Release Notes - Bethesda.net
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The bolt then partially travels down the line to your home.
Why do so many 18 to 29-year-old men struggle in dating?
These are simplified answers to the original question, and does not change anything I wrote above.
One is “what exactly is in a ‘surge protector’ ? ”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What is lightning?
But it can get overloaded, and no longer works.
(Dc diagram shown, AC is similar).
Logitech’s new iPad case has a compact removable wireless keyboard - The Verge
For this case there are devices called Metal oxide varistors (MOV).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
nine
First Sentence:
This is where the MOV conducts again, and dissipated the energy.
[image of Common-mode choke]
The third is lightning and “how it gets conducted into a home.”
He then describes the function of a fuse.
a photo is worth a thousand words.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
An AC voltage/ current source, and an ac inductive load.
This one hit behind the barn.
the problem then depends on "how fast does the fuse operate?".
In schematic diagrams this is the symbol for a fuse:
There are two important concepts here.
Upvotes:
It also is a device that limits the change in current flow.
2024–10–16 [ OO OLAOYE OYEBODE ]
It seems Mohan does not understand the difference between a comment and an Answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
So, the voltage could go up to 500 volts, and the fuse will not open up.
but I think this circuit , shows a few more pieces.
Because the load is inductive, the current lags the voltage.(by a bit).
One
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then describes Rainy Season and Lightning.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Here is a simplified AC power diagram.
A fuse is a non-resetable over current circuit protector.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
These devices are installed between the “hot” and “neutral” and protective ground.
He then asserts :
Barnstars:
2024–10–10[John johnson John Johnson ]
Now when you have a certain ac resistance, then a current flows in a loop.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
so, what happens?
I post the exact comment here.
At least they know the answer if they wanted it.
At one ohm, the resistor has a maximum of 1 watt power.
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is 'the assistant's answer'
There are three different concepts here that are getting confused.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi